Advanced Bionics Harmony User's Guide download pdf (Page 20)

User Guide for the Auria Harmony Sound Processor 19

Part 3: Using Your Harmony Processor

WARNING: While no injury cases have resulted, components of the system may

become hot during normal use or a fault condition. If a particular

device’s temperature results in discomfort or pain, promptly remove

the product and contact your local AB representative.

Turning Your Processor On/Off

The processor does not have an on/off switch. Attaching and removing your Power-

Cel will turn your processor on and off. Remove your PowerCel from your processor

when not in use to optimize battery life.

Wearing Your Processor

WARNING: Your processor has been programmed especially for you. Do

not attempt to use any sound processor that has not been

programmed speciﬁ cally for you. Doing so may provide suboptimal

sound information and could potentially cause physical discomfort.

The processor is designed to be worn behind your ear. When putting on

your processor:

• Turn down the volume on your processor before turning your system on.

• Ensure that a power source has been properly attached.

• Ensure that the headpiece is properly plugged into the processor.

• Place the headpiece on your head over the implant site.

• Turn the volume up to a comfortable listening level.

• If necessary, perform a behavioral check, for example say a few words or check

if the Ling 6 sounds (ah, oo, ee, s, sh, mm) can be detected/repeated.

Figure 17: Wearing the Harmony Processor.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

No comments

Advanced Bionics Harmony User's Guide Page 20